20 silica pool sand7/31/2023 ![]() ![]() IMPORTANT: cover the hole on the top of the hub to avoid the sand going inside, and add the sand gently to avoid damaging the debris screen at the bottom of the tank.Įighth step: position the top part back in place, and tighten the metal ring to close the tank. Seventh step: fill the bottom part with the new sand until it reaches the mark between low and high marked on the hub. Sixth step: take out all old sand from the tank and rinse the bottom part with a garden hose to be sure it is clean. To speed up the operation, position the control valve between two functions.įifth step: open the metal ring in the middle of the tank body and open the upper part of the tank. Fourth step: open the drain valve on the bottom of the sand filter to drain all residual water into the sand filter body. This will make it easier to remove the sand. Third step: disconnect the hoses that connect the sand filter to the pool. If the pool has connection valves, close them. Second step: put the stopper inside the pool to close the valve. Please follow these steps to replace the sand:įirst step: switch off the sand filter and unplug the socket from the power outlet. Closed: This function stops water flowing between the sand filter and the pool. Use this function if the filter is broken to collect debris in the debris screens.Ħ. Circulate: This function circulates pool water bypassing the sand filter. Another filter bypass setting, water is pumped and deposited out of Port D, instead of returning to the pool.ĥ. Drain: This function drains water from the pool. Water is pumped downwards through the sand bed, up through the collector hub and deposited out of Port D.Ĥ. Rinse: This function is for initial startup, cleaning, and sand bed leveling after backwash. Water is pumped down through the collector hub, upwards through the sand bed, and deposited out of Port D.ģ. ![]() ![]() Backwash: This function is used to clean the sand bed. Water is pumped through the sand filter, where it is cleaned and returned to the pool.Ģ. Filter: This function is used to filter pool water and should be positioned here 99% of the time. The filter also works wonderfully with Bestway’s Polysphere™ Filtration Balls.īestway Flowclear sand filters have 6 functions:ġ. The sand is not included with this filter - required sand size is #20 silica sand, 0.45-0.85 mm, approximately 20 kg. This product comes pre-assembled, and is compatible with most 1,100-54,500 L (300 - 14,400 gallon) above ground pools, as it comes with an adapter for pool valves with an outer diameter of 3.8 cm (1.5 in). The filter also comes with the ChemConnect™ Dispenser, which maintains clean, healthy water by providing a stable level of chlorine that is evenly dispersed throughout the pool. The sand will trap dirt and debris, but a pre-filter strainer basket catches larger things so that the pump will last longer. While those cartridges need to be replaced every 2 weeks, silica sand lasts up to 3 years. It is a more cost effective solution as the pump uses silica sand instead of a traditional filter cartridge. (8327 L) Sand Filter from Bestway® is a highly efficient and environmentally friendly way to keep clean water flowing through your above ground pool. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |